High-Speed Sequins for Amazing Effects

Boost your Creativity!

Be on top with the ZSK sequin device

For over 10 years, ZSK sequin devices occupy a top position in the embroidery market. Beside exceptional precision and above average productivity, it is the sensational speed of actually 1.000 stitches per minute which makes them high performance units.

Our engineers have developed a unique embroidery technique which enables you to increase your productivity by 25%. Our sequin devices offer you the chance to benefit above average from the everlasting sequin boom.

ZSK sequin device is available for sequins from 3 to 9mm.

  • The maximum embroidery speed for our sequin device amounts to 1000 r.p.m. In case of the triple fixture, it is possible to attach up to 25% more sequins than usual.
  • Compressed air is not required.
  • Our sequin device is available for sequins from 3 to 9mm.
  • The whole lifting and lowering process is done mechanically and takes only 2 seconds.
  • In case of non-continuous segmented designs the intermediate position is approached and the upper resting position is only approached at the end oft he design or in case of thread breakage.
  • For convenient assembly, the connection between the head cable and the sequin device is provided with a threaded plug.

Our sequin device can be used with::

All tubular embroidery machines

    Transport hole position in front 
Repeat of sequins 5 mm 7 mm 9 mm 10 mm 12 mm 14 mm 16 mm 18 mm 19 mm 20 mm 22 mm
Single-Sequin V6/V6.1   X X X -- -- -- -- -- -- -- --
(V7)   X X X O X X -- -- -- -- --
V8/V9   X X X O X X X X -- -- --
Twin-Sequin T5/T6 Tape A X X X                
Tape B X X X                
    Transport hole position concentric
Repeat of sequins 3 mm 4 mm 5 mm 7 mm 9 mm 10 mm 12 mm 14 mm 16 mm 18 mm 19 mm
Single-Sequin V6/V6.1   X X X X X -- -- -- -- -- --
(V7)   X X X X X O X X X X X
V8/V9   X X X X X O X X X X X
Twin-Sequin T5/T6 Tape A X X X X X            
Tape B X X X X X            

Key

X = processing of respective sequins possible; Ducts existent.
O = processing of respective sequins possible; Ducts non-existent.
-- = processing not possible.

With T5/T6, the width of tape B (=upper tape) must be smaller than or equal to the width of tape B (=bottom tape)!
Thickness of tape max. 0,4 mm (usually 0,12 bis 0,2 mm).
Diameter of transport hole  min. 1,2 mm and max. 2 mm.
Transport hole distance from needle position to cutting position/knife min. 1,5 mm and max. 7,5 mm (V6/V6.1; T5/T6) ; 9,5 mm (V7); 16,5 mm (V8/V9).
Width of sequin tape min. 3 mm and max. 9 mm (V6/V6.1; T5/T6); 19 mm (V7; V8/V9).
Lateral transtport hole position with regard to movement direction/width of tape only concentric.