Download - T8 Software

Download Release 001 / 17.02.2023

Controller MSCF with MCP35 and MCP31 (Sprint 5/6/7 and Racer 1W)

Application:
Control Units T8 and T8-2, for serial machines with F-, W- or K-heads (in any combination)

Supported Languages:
German, English, Italian, French, Russian, Portugese, Dutch, Spanish, Turkish, Polish, Hungarian, Greek, Bulgarian, Romanian

Requirements:
MCP31 EPROM Designation: MCP31_UR V5000 12.03.2009
MCP35 EPROM Designation: MCP35_UR V7000 12.08.2015
MCP41 EPROM Bezeichnung: MCP41_UR V9001 03.11.2022

Download
Release 001 / 17.02.2023 (approx. 16MB) »

Changes / Enhancements:

• Production data acquisition menu: In interaction with MyZSK, it is now possible to request a reason from the operator for stopping the machine manually.
• F-head thread breakage behaviour menu: New setting for forcing the machine to stop at the reset point after thread breakage repair.
• Thread trimming behaviour F-head menu: New setting value for reducing the needle change speed (only with ball screw)
• Needle assignment menu: Duplicate needle assignment to other needles
• Menu MDE: Clear passage counter enabled
• Menu operating modes: New setting value for number of slow stitches after hand bar start.
• Degrees menu: Adjustability of the switching point for switching on the needle at the F head
• Function keys: Auto-repeat for speed +/- realised
• Short intermediate stop when embroidering back before needle change realised
• Support of switching the thread tension at the K-head between moss and warp
• For MCP35 based control systems the software module CON_57xx is still available. 
• Support for MCP41-based control systems and the corresponding software module COS_57xx. 
• Possibility to save screen shots to a USB stick by pressing a key (key combination SHIFT+i).
• Some minor improvements
• Expansion of the ramp status with regard to new machine types and new applications

Last for machines with MCP30 (V40) - Control MSCF

Application:For serial machines with F-, W- or K-heads (in any combination) as well as ZANX-series.
Machines with  MCP30 - Controls MSCF

Supported Languages:
German, English, Italian, French, Russian, Portugese, Dutch, Spanish, Turkish, Polish, Hungarian, Greek, Bulgarian

Download
Last Release for MCP30 (V40) / 29.05.2020 »

Last for machines with CPU4i MCP24 (V40) - Controls MSCF, MSCI

Application: For serial machines with F-, W- or K-heads (in any combination) as well as ZANX-series.
Machines with CPU4i MCP24 (V40) • Controls MSCF, MSCI

Application: For serial machines with F-, W- or K-heads (also in any combination) as well as ZANX series.
Maschines with CPU4i MCP24 (V40) • Controls MSCF, MSCI

Supported Languages:
German, English, Italian, French, Russian, Portugese, Dutch, Spanish, Turkish, Polish, Hungarian, Greek, Bulgarian

Download
Last Release for CPU4i MCP24 (V40) / 10.06.2016 »